BELFRY USER MANUAL
Sun-and-moon automatic watch
User manual
With the crown at position I, turn it clockwise approximately 30 times to start the watch.
Note: Your automatic watch is powered by wrist movement. If it has not been worn for more than 24 hours, wind it manually.
1. Pull the crown out to position III.
2. Turn the crown clockwise to set the correct time.
3. Push the crown back to its original position. The seconds hand will start moving immediately.
The sun-and-moon display completes one cycle every 24 hours and adjusts automatically when you set the time.
Before setting the date:
Make sure the watch shows 12 noon and the sun-and-moon display points to the 12 o'clock position.
1. Pull the crown out to position II.
2. Turn the crown anticlockwise to adjust the date.
3. When finished, push the crown back to its original position.
1. Slide the quick-release lever on the back of the strap inwards to remove the strap.
2. Position the replacement strap.
3. Insert one end of the spring bar into the lug hole, then slide the lever inwards to fit the other end into the opposite lug hole.
⮕Watch the full strap tutorial