MARINUS USER MANUAL
Automatic dive-style watch
Video tutorial
User manual
The screw-down crown has a locking mechanism.
Turn the screw-down crown anticlockwise to unlock it before making any adjustments.
When finished, push the crown back to position I and screw it clockwise to lock it. This helps prevent accidental operation and maintains water resistance.
With the crown at position I, turn it clockwise approximately 30 times to start the watch.
Note: Your Marinus automatic watch is powered by wrist movement. If it has not been worn for more than 24 hours, wind it manually.
1. Pull the crown out to position III.
2. Turn the crown clockwise to set the correct time.
3. Push the crown back to its original position. The seconds hand will start moving immediately.
4. When finished, screw the crown clockwise to lock it and prevent accidental operation.
Before setting the date:
Make sure the watch shows 12 noon.
Advance the hands clockwise. When the date changes, the watch is passing through midnight into the morning.
1. Pull the crown out to position II.
2. Turn the crown anticlockwise to adjust the date.
3. When finished, push the crown back to its original position.
Preset the unidirectional rotating bezel to measure elapsed time from the start of an event.
Align the triangular marker: Turn the bezel until the triangular marker lines up with the minute hand.
Read the bezel scale at the minute hand.
The minute hand's position on the rotating bezel indicates the elapsed time.
1. Prepare a bracelet link-removal tool.
The small arrows on the back of the links indicate the direction in which the pins should be pushed out.
2. Turn the tool clockwise to push its tip into the recessed pin opening, driving the pin out to separate the bracelet.
3. Align the links and insert the removed pin into the link hole with the rounded end facing down. Gently tap it into place with a plastic installation hammer until fully secured.
4. Fine-adjust the bracelet length.
Use a pointed spring-bar tool to press the spring bar at the clasp, then gently pull the bracelet to release it.
Refit the spring bar in the appropriate position, inserting one end into the small clasp hole followed by the other end.
⮕Watch the full strap tutorial
