MERIDIAN USER MANUAL
Moonphase quartz watch
Setting instructions
User manual
1. Pull the crown out to position III.
2. Turn the crown clockwise to advance the hour and minute hands and set the day.
3. When finished, push the crown back to its original position.
The day, hour hand and minute hand are adjusted using the same operation.
1. Pull the crown out to position III.
2. Turn the crown clockwise to set the correct time.
3. Push the crown back to its original position. The seconds hand will start moving immediately.
The day of the week, hour and minute are set by the same operation.
Before setting the moonphase, make sure the watch shows 12 noon.
Advance the hands clockwise. When the date changes, the watch is passing through midnight into the morning.
Consult a reliable source for the current moon age. For the most accurate setting, adjust at a new moon (day 0) or full moon (day 15).
The average lunar cycle is 29.5 days.
1. Pull the crown out to position II.
2. Turn the crown clockwise to set the moonphase.
3. When finished, push the crown back to its original position.
Before setting the date, make sure the watch shows 12 noon.
Advance the hands clockwise. When the date changes, the watch is passing through midnight into the morning.
1. Pull the crown out to position II.
2. Turn the crown anticlockwise to set the date.
3. When finished, push the crown back to its original position.
1. Slide the quick-release lever on the back of the strap inwards to remove the strap.
2. Position the replacement strap.
3. Insert one end of the spring bar into the lug hole, then slide the lever inwards to fit the other end into the opposite lug hole.
⮕Watch the full strap tutorial