NEW YORK USER MANUAL
Automatic watch
User manual
With the crown at position I, turn it clockwise approximately 30 times to start the watch.
Note: Your New York automatic watch is powered by wrist movement. If it has not been worn for more than 24 hours, wind it manually.
1. Pull the crown out to position III.
2. Turn the crown clockwise to set the correct time.
3. Push the crown back to its original position. The seconds hand will start moving immediately.
Before setting the date:
Make sure the watch shows 12 noon and the sun-and-moon indicator points to the 12 o'clock position.
Advance the hands clockwise. When the date changes, the watch is passing through midnight into the morning.
1. Pull the crown out to position II.
2. Turn the crown anticlockwise to set the date.
3. When finished, push the crown back to its original position.
1. Slide the quick-release lever on the back of the strap inwards to remove the strap.
2. Position the replacement strap.
3. Insert one end of the spring bar into the lug hole, then slide the lever inwards to fit the other end into the opposite lug hole.
⮕Watch the full strap tutorial
1. Insert the supplied strap adjustment tool into the opening in the clasp.
2. Gently press the tool down to lift the adjustment plate.
3. Slide the clasp to suit your wrist, then press the adjustment plate firmly back into place.
⮕Watch the full strap tutorial
1. Hook the clasp onto the crossbar and pull down to make sure it is securely engaged.
2. Close the safety clasp.
Note: After putting on the watch, make sure the clasp is securely fastened.